Month: December 2018

The external shell perimeters is the number of perimeters which build the plastic external shell – the most precise one.

The generate reinforced perimeters flag is the flag which indicates that the Aura will generate reinforced perimeters for printed parts.

The use fiber flag is the flag which indicates that parts may be reinforced with fiber.

The cooling fan index is the number of this cooling fan in printer firmware.

The cooling fan index is the number of this cooling fan in printer firmware.

The has cooling fan flag is the flag which indicates thar extruder has a nozzle cooling fan.

The cut G-code is the code, that actuates fiber cutting. This value should be set only by printer manufacturer.

The fiber restart length is the length of fiber extrusion during restart. This is necessary for the fiber tail to get out of the nozzle. This parameter should be greater than or equal to the cut distance. For Anisoprint Composer this parameter is lagrer than the cut distance for 1-2mm.

The cut distance is the distance from a cut point to outlet hole of a nozzle. This value should be set only by printer manufacturer.

Z offset is the extruder Z offset relatively to the base point on a print head. If your printer has only one extruder then set this parameter to zero. If printer firmware doesn’t set offset by itself then you should set other extruders offsets relative to base (usually first) extruder. In this case you sholud set offsets for this base extruder offsets to zero.