There are two options to get minimum temperature error on the Composer.
- In standby mode, when you see temperature -242 С° on one of the extruders
- During printing, when you get MINTEMP trigger error
This error comes, when Composer get temperature from one of the extruders (Heater_ID) less than 10 C°
To identify the cause of the error, you need to check the temperature sensor. Operating procedure will be:
- Turn off the printer
- Remove the protective cover from the print head
- Disable flat cables
- Measure the resistance at the defined connectors.
If the measured resistance is close to the correct (0.4-1 Om), it’s means that the temperature sensor works good. You will need to contact your local distributor or write us on support@anisoprint.com