The Z travel speed is the linear speed of print head movements in the Z direction without extrusion.
Category: Aura
X/Y travel speed (mm/sec)
The X/Y travel speed is the linear speed of print head movements in XY plane without extrusions.
Height (mm)
The height is the size of build area along the Z axis.
Length (mm)
The length is the size of build area along the Y axis.
Width (mm)
The width is the size of build area along the X axis.
Linear density (tex = g/km)
Linear density is the mass of 1km of fiber in grams.
Do plastic retract
The do plastic retract flag is the flag which indicates that plastic retract should be performed during composite printing.
Finish ironing distance (mm)
Finish ironing distance is the length of travel which is performed by a composite nozzle at the end of fiber polygon in the direction of last segment. It happens after cut and full exit a of fiber tail. This movement is needed for ironing tail which, if not done, will be fluffy.
Restart pause (sec)
Restart pause is the delay before start of composite polygon printing. This is needed for the good adhesion between a fiber tail and an a underlying layer.
Fiber extrusion speed (mm/sec)
Fiber extrusion speed is the speed of the fiber tail extrusion.
